Panasonic SC-HT744 FM frequency step, Using an outdoor antenna optional, Using the radio

∫FM frequency step

Main unit only

The step is factory-set to 0.2-MHz, but you can change it to receive broadcasts allocated in 0.1-MHz steps.

1Press [SELECTOR] to select “FM”.

2Press and hold [SELECTOR].

After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed.

To return to the original step, repeat steps 1 and 2.

[Note]

After changing the setting, previously preset frequencies will be cleared. Preset them again.

Using an outdoor antenna (optional)

Use outdoor antennas if radio reception is poor.

≥Disconnect the antenna when the unit is not in use.

≥Do not use the outdoor antenna during an electrical storm.

FM outdoor antenna (Using a television antenna)

≥Disconnect the FM indoor antenna.

≥The antenna should be installed by a competent technician. Rework your outdoor antenna’s 75 ≠ coaxial cable as follows.

	LOOP
	ANT GND
75 ≠ coaxial cable	FM ANT
	75
	LOOP
(not included)

Antenna plug	AM
	ANT
(not included)	EXT

Leave the AM loop antenna connected.

AM outdoor antenna (Using a vinyl wire)

Run a piece of vinyl wire horizontally across a window or other convenient location.

5 to 12 m

(16 to 39 feet)

Using the radio

1 Remove a piece of the outer		2 Carefully pull the tabs		3 Install the coaxial cable.	4 Attach the cover.
vinyl insulator.		apart to remove the cover.		Clamp the cable conductor,
				and wind it on so that it does
				not contact anything else.
	10 mm (13/32z)
			2
10 mm (13/32z)	Peel back	1	1
				Clamp with pliers
7 mm (9/32z)

RQT8720

29