Ingersoll-Rand 8670-( )-3( ), 8670-( )-1( ) manual Valve Assembly

Page 9

NOTE: When assembling needle valves (34617), install with top of needle valve flush with top of valve block (44927).

b.Assemble valve assembly (45174) to valve housing (44919) with gasket (44948) and nameplate (45184) and secure with five screws (Y211-109) and washers (Y14-10)

M105

40

NOTE: When replacing gaskets, torque cap screws to 20 in. Ibs and re-torque after 24 hours to remove gasket set.

44979 VALVE SLEEVE

/

45174 VALVE ASSEMBLY

PARTS MARKED THUS ARE INCLUDED IN SERVICE KIT NUMBER 45632, SEE PAGE 20.

9

Image 9

Contents SELF-FEED Drill Valve Section Model IdentificationMounting SET-UP ProcedureMaintenance Disassembly and Assembly of ToolsAIR and Lube Requirements M105 Disassembly AssemblyGearing Section POSlTlON Bearings with Shielded Side AS Shown Motor Assembly Motor SectionValve Section Valve Assembly Housing and Valve Section Typical Cross Section of Tool SET-UP Procedures AccessoriesHydraulic Check Mounting InstructionsSET-UP Procedure Double Hydraulic Check AssembliesSpanner Wrench Foot Mount Assembly Nose Housing Tool Is designed Todeliver Recommended Power AIR Inlet SystemRemote Operation Basic Remote Control for Start Emergency Retract FunctionsPage Maintenance Tool Furnished with Each Model Trouble ShootingTool Retracted Port Service KIT no