Contents of the Shipping Container

1. Mill/Drill Machine

Accessory Package:

1. 1/2” Drill Chuck w/ Chuck Key

1. Adjustable Carbide Facemill

1.Facemill Arbor

2.Bolts, Nuts, and Washers to Attach Vise to Table

1. 2-1/2” Angle Vise (JMD-15)

1. 3-1/2” Angle Vise (JMD-18/18PFN)

3. Handle Rods

3. Rubber Knobs

1. 3/8”x1” Hex Socket Cap Screw

1. 3/8” Washer

1. Crank Body

1. Crank Handle

1. 3mm Hex Wrench

1. 5mm Hex Wrench

1.23mm Hex Socket Wrench (JMD- 18/18PFN)

3. Hand Wheels w/ Handles

1. Can Touch-Up Paint

1. Owner’s Manual

1. Warranty Card

1. Lifting Hook

Unpacking and Clean-up

1. Finish removing the crate from the mill/drill.	(JMD-18 shown with optional CS-18 stand)
Unbolt the machine from the crate bottom.
Report shipping damage, if any, to your
distributor.

2.Clean all rust protected surfaces using a mild commercial solvent, kerosene or diesel fuel. Do not use paint thinner, gasoline, or lacquer thinner. These will damage painted

surfaces. Cover all cleaned surfaces with a light film of Mobil DTE Oil Heavy Medium.

Tools Needed for Assembly

8” Adjustable Wrench or 1/4” to 1-1/4” Combination Wrench Set