PREFACE TO THE MANUAL
These operating instructions apply exclusively to drill stand, type DS 160 C. Please also read the operating instructions that accompany your drill motor to verify their compatibility and not to exceed the limitations of the DS 160 C drill stand.
Usage to the Intended Purpose
The drill stand is designed exclusively for core drilling in concrete, asphalt, brickwork or similar building materials. Details of the maximum permissible drill bit diameter can be found under “Technical Specifications”. Any use above and beyond the intended purpose endangers both user and machine and is not permitted.
Before commencing drilling, always ensure that;
there is no danger of drilling through electric cables, gas, oil or other pipes, the drilled holes do not undermine the stability of the structure,
you do not drill into or through any steel girders,
when drilling through walls, you cannot cause any damage at the drill exit point. Strict care must be taken when drilling in areas where people or general public are present. Local codes dictate proper protocol and must be observed.
Improper Usage
The drill stand must not be used for any kind of stirring, e.g. paint or similar; drilling holes in soil, e.g. to drill holes for posts.
The drill stand must be mounted via anchor bolt or vacuum, do not attempt to drill hand held or standing on base plate.
This drill stand incorporates the expertise of decades of experience in the field of concrete drilling.
Before leaving our factory every machine passes an inspection program in which everything is checked completely.
Following the instructions will ensure that your machine gives long service, in normal operating conditions.
The user advice and spare parts mentioned in this document are given as an indication and do not constitute an undertaking. No warranty will be granted in the event of errors or omissions or for damage occurring during delivery or caused by the design or use of this machine. We are very concerned about the quality of our products and we serve the right to make any technical modifications to improve them without warning.
This document will assist the user particularly in:
·Information about the machine
·Information about its possible uses
4