ASSEMBLY
Installingor removing driver bit or drill bit
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the bit
Hold the ring and turn the sleeve counter- clockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Hold the ring firmly and turn the sleeve clock- wise to tighten the chuck.
To remove the bit, hold the ring and turn the sleeve counterclockwise.
OPERATION
Switch action
Tool speed is increased by increasing pres- sure on the trigger. To start the tool, simply pull the trigger. Release the trigger to stop.
Switch
trigger
CAUTION:
Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released
Reversing switch action
This tool has a reversing switch to change the direction of rotation. Slide the reversing switch to the left for clockwise rotation or to the right for counterclockwise.
switch
CAUTION:
*Always check the direction of rotation before operation.
*Move the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool.
8