Makita 6OLODWK instruction manual Clip-on chuck key

Bit installation & removal

CAUTION :

Always set the Forward-Reverse switch lever to NEUTRAL when installing, removing or adjusting bits or accessories.

Chuck

When installing a drill bit, notice that there are three holes in the chuck a t which you must use the key for tighten- ing. Insert the chuck key in any of the 3 holes and turn to the left (counterclock- wise) to release jaws of chuck. Insert the bit and tighten with chuck key to the right. Tighten evenly a t all three holes in sequence.

1 Clip-on chuck key

Overload protector

The overload protector automatically cuts in to break the circuit and the button pops out, whenever heavy work i s prolonged. Wait 20-30 seconds before pressing the restart button (on housing in back) to resume operation. Your finger should not be on the trigger when you press the restart button, however.

I" / Overload protector