*Pressing down too hard on the tool will not speed up the drilling. In fact, this undue pressure will only serve to damage the tip of your drill bit, decrease your drilling per- formance and shorten the service of the tool.
*There is a tremendous force exerted on the tool/bit a t the time of hole break through. Grip the drill firmly and exert care when the bit begins to break through the materials.
Screw
Match your bit to your screw.
1. Phillips bits
Phillips bit No. 2 - 45 mm is standard equipped. Select your screws and nominal diameter with the chart on the right.
*IItemNominal Diameter (mm)
B i t No.Wood Screw
2.1 - 2.7 13/32" - lis")
No. 2 3.1 - 4.8 (118'' - 3/16")
2.Slotted bits
Unless you use a bit that fits properly the slot on the head of the screw, the slot will be damaged and the screw will not fasten. If the bit fails to match the slot, use a grinder or some such tool to trim the bit to fit the slot.
NOTE : Rest the tool for 15 minutes when changing battery for continuous operation.
9