0 When you charge a new battery cartridge or a battery cartridge which has not been used for a long period, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it almost completely a couple of times.
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the fast charger.
Selectingaction mode
Rotation with hammering:
For drilling in brick, concrete block, etc., move the change lever to the 0 0 0 9 posi- tion. Be sure to use a concrete and masonry drilling bit.- Rotation only :
For drilling in wood, metal or plastic mate- rials, move the change lever to the position. Use a conventional bit for drilling in wood or metal.
Installing or removing drill bit or driver bit
CAUTION :
Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the bit.
To install the bit, place it in the chuck as
far as it will go. Tighten the chuck byChuck key hand. Place the chuck key in each of the
three holes and tighten clockwise.
Be sure to tighten all three chuck holes evenIy .
To remove the bit, turn the chuck key counterclockwise in just one hole, then loosen the chuck by hand.
I Chuck ke7
7