Charging
Uncao the connector hole.
Connect the charging plug to the charging connector, then plug in the charger to the
CAUTION :
The battery in your new tool is not fully charged. You will need to charge it before use.
Do not operate the tool during charging.
Overcharging more than 2 days considerably shortens the battery service life. Always unplug the charger after completing the charge. Then cap the charging connector hole.
When you charge a new tool or a tool which has not been used for a long period, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the tool fully after discharging it almost completely a couple of times.
Installing or removing drill bit or driver bit
Always set the reversing switch lever to the neutral position before installing or removing the bit.
To install the bit, place it in the chuck as far as it will go. Tighten the chuck by hand. Place the chuck key in each of the three holes and tighten clockwise.
Be sure to tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise in just one hole, then loosen the chuck by hand.
6