_1= WARNING: Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.
_k WARNING: Do not allow familiarity with your
CHARGING YOUR DRILL-DRIVER
The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it until light on front of charger changes from red to green.
Note: Battedes will not reach full cha_ge the first time they are charged. Allow several cycles (drilling followed by recharging) for them to become fully charged.
TO CHARGE
•Charge battery pack only with the charger provided.
•Make sure power supply is normal house voltage, 120 volts, 60 Hz, AC only.
•Connect charger to power supply.
•Place battery pack in charger aligning raised rib in charger with groove in battery pack.
•Press down on battery pack to be sure contacts on
battery pack engage properly with charger contacts.
•Normally, the yellow and green lights on charger
.will come on. This indicates charger is in soft stad mode and should switch to fast charge mode within 5 minutes. When charger is in fast charge mode the red light will come on. If after a period of 15 minutes the yellow and green lights remain on, remove battery pack, wait I minute and reinsert
| battery pack in charger. If the yellow and green | H |
| lights continue to remain on after an additional 15 | |
| minutes, the battery pack is damaged and will not | |
| accept a charge. Return battery pack to your | |
| nearest Sears Repair Center for checking or | |
| replacing. | |
• | When your battery pack becomes fully charged, the | |
red light will turn OFF and the green light will turn | ||
| ON. |
|
• | After normal usage, 1 hour of charging time is |
|
| required to be fully charged. A minimum charge |
|
| time of |
|
| completely discharged tool. |
|
• | The battery pack will become slightly warm to the |
|
| touch while charging. This is normal and does not |
|
| indicate a problem. |
|
• | Do not place charger in an area of extreme heat or |
|
| cold. It will work best at normal room temperature. |
|
,_ CAUTION: Your
help prevent battery damage when left on charge for extended periods of time. However, once the batteries become fully charged, we recommend that you unplug your charger from power supply and remove the battery pack.
7