SWITCH
See Figure 2.
To tum your drill ON, depress the switch tdgger. To tum it OFF, release the switch tdgger.
CENTERPosmoN
SELECTOR
TRIGGER
Fig. 2
TO INSTALL BATTERY PACK
•Lock switch trigger on your drill by placing the direction of rotation selector in center position. See Figure 2.
•Place battery pack in your drill. Align raised rib inside drill with groove on battery pack. See Figure 3.
BATrERYPACK
SWITCH LOCK
See Figure 2.
The switch trigger can be locked in the OFF position. This feature can be used to prevent the possibility of accidental starting when not in use. To lock switch trigger, place the direction of rotation selector in center position.
AWARNING: Battery tools are always in operating condition. Therefore, switch should always be locked when not in use or carrying at your side.
VARIABLE SPEED
This tool has a variable speed switch that delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.
Note: You might hear a whistling or ringing noise from the switch during use. Do not be concerned, this is a normal part of the switch function.
LATCHES
DEPRESSLATCHESTO |
|
RELEASEBATI'ERYPACK | Fig. 3 |
•Make sure the latches on each side of your battery pack snap in place and battery pack is secured in drill before beginning operation.
ACAUTION: When placing battery pack in your drill, be sure raised rib inside drill aligns with
groove on battery pack and latches snap in place properly. Improper assembly of battery pack can cause damage to internal components.
TO REMOVE BATTERY PACK
•Lock switch trigger on your drill by placing the - direction of rotation selector in center position.
See Figure2.
•Locate latches on end of battery pack and depress to release battery pack from your drill. See Figure 3.
•Remove battery pack from your drill.
8