2.Tilt the table to the desired angle as indicated on the bevel scale.
3.Tighten the screw under the table by rotating it in a clockwise direction.
Note. When the table is tilted the workpiece should be clamped to the table.
Installing and removing drill bits
CAUTION. Always ensure that the drill press is switched off and the plug is removed from the power point before making any adjustments.
1.Using chuck key (18) loosen the chuck jaws by rotating the chuck key in an anti- clockwise direction.
2.Fit the drill bit into the chuck (12) and ensure it is fully inserted.
3.Rotate the top collar by hand in an
4.Using the chuck key tighten all 3 holes to secure the drill bit. Tighten the holes by rotating the chuck key in a clockwise direction.
Setting the drilling depth
CAUTION. Always ensure that the drill press is switched off and the plug is removed from the power point before making any adjustments.
1.Loosen the handle screw half a turn using the depth locking knob (16).
2.Ensuring the drill bit is tight in the chuck use the feed wheel to lower the spindle until the drill bit just touches the workpiece.
3.Holding the handle in that position rotate the depth scale (15) to the desired drilling depth.
4.Tighten the depth locking knob (16) firmly to secure the handle in position.
5.Lift the handle up and then proceed with the drilling operation.
6.To disable the depth lock loosen the depth locking knob and rotate the depth scale to the maximum depth.
7.Tighten the depth locking knob firmly to secure the handle in position.
Note. If the depth locking knob needs to be tighter use the 5mm hex key supplied to tighten the hex screw on the inside of the depth locking knob.
10