Assembly

1.Place base (6) on floor.

2.Place column assembly (7) on base and align the 3 holes in the column assembly with the holes in the base.

3.Using the 3 bolts secure the column support to the base and tighten with a 13mm wrench.

4.Fit the table (8) over the column and secure to the column using the table lock (9).

5.Fit the motor head (13) to the top of the column and tighten the 2 grub screws using the 4mm hex key. This will secure the head on the column.

6.Fit the 3 handle rods to the handle hub on the drill press head, attach them by rotating each handle in a clockwise direction.

7.Fit the chuck (12) onto the spindle and secure it by pushing it and giving it a sharp tap.

Note. Ensure both surfaces are clean before putting the chuck on the spindle.

Adjusting the table height

CAUTION. Always ensure that the drill press is switched off and the plug is removed from the power point before making any adjustments.

1.Loosen the table lock (9).

2.Raise or lower the table to the required height

3. Tighten the table lock to secure the table.

CAUTION. Always ensure that the drill press is switched off and the plug is removed from the power point before making any adjustments.

1.Loosen the screw under the table by rotating it in an anti-clockwise direction using a 19mm wrench.