the bit exits the workpiece. Lubricate the Drill Bit with cutting oil when drill- ing iron or steel. Use a coolant when drilling nonferrous metals such as copper, brass, or aluminum.
8.When the hole is drilled, remove the drill bit from the hole while the Drill is still running. This prevents the Drill Bit from getting caught in the hole and causing damage.
9.Please Note: The Drill/Driver has an LED light that shines on contact area. Lightly tapping on the Trigger will activate the LED light.
10.To prevent accidents, turn off the tool and disconnect its power supply after use. Clean, then store the tool in- doors out of children’s reach.
Maintenance And
Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation: Turn Power Switch of Tool to its “OFF” position and remove Battery Pack from tool performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury from tool failure: Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning, Maintenance, and
Lubrication
1.BEFORE EACH USE, inspect the general condition of the tool. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, and any other condition that may affect its safe operation.
2.After Use, clean external surfaces of the tool with clean cloth.
3.
WARNING! Do not use if either the Battery Pack or Charger are damaged in any way.
SKU 67089 | For technical questions, please call | Page 8 |