14.Operate the Drill by squeezing the Trigger (12). The speed of the Drill can be con- trolled by varying the pressure on the Trigger.
15.If the clutch starts slipping before the screw is in all the way, stop the drill, put the Rotation Button (6) in the center position and change the torque setting. Reset the rotation direction before continuing.
16.If Drilling:
Use the Drill torque setting, as described above.
Drill only as deep as necessary. Do not drill deeper than necessary into walls or other areas where you cannot identify any possible hazards behind the drilling surface.
To reduce jamming as the Bit breaks through the workpiece, decrease the drilling pressure when the point of the Bit breaks through the workpiece.
17.When you have drilled the hole, remove the Bit from the hole while the Cordless Drill is still running. This prevents the Bit from getting caught in the hole and caus- ing damage.
18.Release the Trigger (12) to stop the Drill, put the Rotation Button in the center posi- tion, and remove the bit from the Drill.
INSPECTION, MAINTENANCE, AND CLEANING
1.WARNING! Remove the Battery Pack (19) from the tool and set the Rotation Button (6) to the center locked position before performing any inspection, maintenance, or cleaning.
2.BEFORE EACH USE, inspect the general condition of the Cordless Drill/Driver. Check for misalignment or binding of moving parts, cracked or broken parts, leaking Battery Pack, damaged Charger wiring, chipped or broken Drill Bits, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
3.After each use: With a soft brush or cloth, remove all dirt and debris from the Cordless Drill/Driver. Do not immerse the Cordless Drill/Driver in any liquids.
4.When the battery needs to be replaced remember that the lithium battery in this tool must be recycled or disposed of properly.
SKU 96299 | For technical questions, please call | PAGE 12 |