Charging
1.The Battery Pack (19) requires charging before the initial use. The recommended initial charge time is twelve hours, prior to initial use of the Cordless Drill/Driver. Place the Charger on a solid surface such as a garage floor; never on anything flammable.
Note: Always switch to a fresh battery when tool performance begins to diminish. Severe heat is destructive to batteries; the more heat generated, the faster the battery will lose power. A battery that gets too hot can be permanently damaged. Never over- discharge a battery by using the tool after performance decreases. Never attempt to discharge a battery by continuing to pull the trigger. When tool performance begins to diminish, stop the tool, recharge the battery, and use a fully charged battery for optimal performance.
2. | When the Battery | |
| five to seven hours in order to operate at full power. |
|
3. | Charging room temperature: 50° F. – 104° F. |
|
4. | Depress both buttons at the rear of the Battery Pack and slide the unit down to | |
| detach from the Drill/Driver. |
|
5. | The Battery Pack can only fit into the Charger (20) in one position, insert into Char- | |
| ger, plug Charger into Adapter (21), and plug | Battery |
| Adapter into any standard electrical outlet. | |
| Pack (19) | |
6.While charging, the Battery Pack, Charger, and Adapter may become warm to the touch. This is normal, and does not indicate a prob- lem.
7.When the Battery Pack is in the Charger, both the red and green lights on the Charger will be illuminated while charging, when the Battery Pack is fully charged the red light will turn off, indicating that the Battery Pack is ready for use. Once the Battery Pack is fully charged, unplug the Charger from the electrical outlet and remove the Battery Pack from the Adapter.
Charger (20)
Adapter (21)
SKU 96299 | For technical questions, please call | PAGE 9 |