KEYLESSCHUCK SeeFigure5.
YourdrillhasakeylesschuckAsthenameimplies,you.
canhandtightenorreleasedrillbitsinthechuckjaws.
Graspandholdthecollarofthechuckwithonehand.
RotatethechuckbodywithyourotherhandThearrows. onthechuckindicatewhichdirectiontorotatethechuck
bodyinorderto LOCK(tighten)orUNLOCK(release) thedrillbit.
| UNLOCK |
|
| (RELEASE) |
|
DRILLBIT | _ | CHUCKBODY |
| 4! |
|
INSTALLING BITS
See Figure 7.
[] Lock switch trigger on your drill by placing the direction of rotation selector in center position. See Figure 2.
[] Open or close chuck jaws to a point where the opening is slightly larger than the bit size you intend to use. Also, raise the front of your drill slightly to keep the bit from falling out of the chuck jaws.
[] Insert drill bit straight into chuck the full length of the jaws as shown in figure 7.
| UNLOCK |
|
DRILL BIT | (RELEASE) | CHUCKBODY |
_ | ||
| 41 |
|
| CHUCK | ib, |
|
|
| JAWS | I |
| |
|
| LOCK |
| |
|
| (TIGHTEN) | CHUCKCOLLAR | Fig. 5 |
_ | ARNING: | Do not hold chuck body with | one | |
hand and use power of the drill to tighten chuck jaws on drill bits. Chuck body could slip in your hand or your hand could slip and come in contact with rotating drill bit. This could cause an accident resulting in serious personal injury.
BIT STORAGE
See Figure 6.
When not in use, bits provided with your drill can be placed in the storage area located on the top of your drill as shown in figure 6.
SCREWDRIVER
BITS
AREA
Fig. 6
CHUCK
JAWS
|
| LOCK |
|
|
|
| (TIGHTEN) | CHUCKCOLLAR |
|
|
| RIGHT | Fig. 7 | |
[] | Tighten the | chuck jaws on drill bit. |
| |
[] | To tighten the chuck jaws | on drill bit; grasp | and | |
| hold the collar of the chuck with one hand, while | |||
| rotating the | chuck body with your other hand. | ||
| Note: Rotate the chuck body in the direction of | |||
| the arrow marked LOCK to tighten chuck jaws. | |||
[] | Do not use | a wrench to tighten or loosen the | ||
| chuck jaws. |
|
|
|
_IL ARNING: Make sure to insert drill bit straight into chuck jaws. Do not insert drill bit into chuck
jaws at an angle and then tighten, as shown in figure 8. This could cause drill bit to be thrown from drill, resulting in possible serious personal injury or damage to the chuck.
Fig. 8
11