KNOW YOUR HAMMER DRILL
See Figure 1.
Before attempting to use your hammer drill, familiarize yourself with all operating features and safety requirements.
,_ WARNING: Carefully read through this entire owner's manual before using your new hammer drill. Pay close •
attention to the Rules For Safe Operation, Warnings and Cautions. If you use your hammer drill properly and only for what it is intended, you will enjoy years of safe, reliable service.
_L WARNING: Do not allow fam)liarity with your hammer drill to make you careless. Remember that a careless
fraction of a second is sufficient to inflict severe injury.
KEYLESS CHUCK
Your hammer drillhas a keyless chuck that allows you to hand tighten or release drill bit in the chuck jaws.
SWITCH
To turn your hammer drill ON, depress tile switch trigger. Release switch trigger to turn your hammer drill OFF.
SWITCH LOCK
The switch trigger can be locked in the OFF position. This feature helps reduce the possibility of accidental starting tool when not in use.
VARIABLE SPEED
This tool has a variable speed switch that delivers higher speed with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.
TWO SPEED GEAR TRAIN
Your hammer drill has a two speed gear train designed for drilling or driving at HI or LO speeds. A slide switch is located on top of your drill to select either HI or LO speed.
FORWARD/REVERSE SELECTOR (DIRECTION OF ROTATION SELECTOR)
Your hammer drill has a forward/reverse selector located above the switch trigger.
WRIST STRAP
A wrist strap is provided to reduce the chances of dropping your hammer drill. Place one hand through the wrist strap when carrying tool.
BIT STORAGE
When not in use, bits provided with your hammer drill can be placed in the storage area located on the top of the motor housing.
LEVEL
To keep drill bit level during drilling operations, a level is located on the top and end of the motor housing.
AUXILIARY HANDLE
An auxiliary handle is packed with your hammer drill for ease of operation and to help prevent loss of control.
DEPTH GAGE ROD
A depth gage rod has been packed with your hammer drill to assist you in controlling the depth of drilled holes.
_1, WARNING: If any parts are missing, do not operate your hammer drill until the missing parts are replaced. Failure to do so could result in possible serious personal injury.
| PRODUCT | SPECIFICATIONS: |
|
HAMMER | DRILL | 315.271270 | |
Chuck |
| 1/2 in. Keyless | |
Motor |
| DC Motor | 18 Volt |
Gear Train | Two | Speed | |
Switch |
| Variable | Speed |
No Load Speed | |||
|
| ||
Hammer | Speed | (Low) | |
|
| (High) | |
Clutch |
| 24 Positions |
Maximum | Torque | 500 in./Ibs. |
CHARGER |
| ITEM NO. |
Input |
| 120 V, 60 Hz, AC only |
Charging | Voltage | 9.6 - 24 Volt |
Charge Rate | 1 Hour | |
BATTERY | PACK | ITEM NO. |