DIRECTION-OF-ROTATION SELECTOR (FORWARD/CENTER LOCK/
REVERSE) (Fig. 5)
The direction of bit rotation is reversible and is controlled by a selector located above the trigger switch. With the
1.Position the
2.Position the
3.Setting the switch in the OFF (center lock) position helps reduce the possibility of accidental starting when not in use.
_i, CAUTION: To prevent gear damage, always allow the 12V
Impact Driver to come to a complete stop before changing the direction of rotation.
NOTE: The 12V
ELECTRIC BRAKE
To stop the 12V
LED WORKLIGHT (Fig. 7)
Fig. 7
The LED worklight, located on the front of the 12V
Impact Driver, will illuminateLED Worklight when the trigger switch is
depressed.
This provides additional light on the surface of the workpiece for operation in
The LED worklight will turn off when the trigger switch is released.
INSTALLING BITS (Fig. 8)
1. Lock the trigger | switch | by | Fig. 8 | |
placing the |
| |||
|
| |||
rotation | selector | in the | OFF |
|
(center) | position. |
|
|
|
2. | With one hand, pull the |
| ||||
| sleeve toward | the | front | of | ||
| the | tool, | and hold | it in place. | ||
3. | With | the | other | hand, insert | ||
| a | shank | bit | into | the |
FuelGauge (Fig. 6)
This tool is equipped with a
FuelGauge that indicates the Fig. 6 battery pack charge level.
The green LED on the FuelGauge indicates that the battery is fully charged.
The orange LED on the FuelGauge indicates that the battery has used approximately one half of its charge
The red LED on the FuelGauge indicates the battery pack
is depleted and needs to be charged.
tP
FuelGauge
J.z/
C
hexagonal hole in the bit |
retainer. |
4. Release the sleeve and |
check that it returns to its |
original position. |
_i, WARNING: If the sleeve does not return to its original position, the bit is not correctly installed. Retry until the bit is properly installed.
WARNING: Use protective gloves when removing the bit from the tool, or first allow the bit to cool down. The bit may be hot after prolonged use.
REMOVING BITS (Fig. 8)
1.Lock the trigger switch by placing the
2.Pull the sleeve towards the front of the tool, and hold it in place.
3.Remove the bit from the hexagonal hole in the bit retainer.
4.Release the sleeve.
17562 ManuaLRevised_$O | 0607 | Page 16 | 17562 ManuaLRevised_lO | 0607 | Page 17 |