Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Charging the Battery Pack
The Battery Pack (ITEM 68059) needs to be charged before first use. Recharge the Battery after every use.
1.Remove the Battery Pack by pressing on the striped side tabs and sliding it out. Then set the Pack and Charger on a dry fireproof surface in a room where the temperature ranges from
NOTE: Allow a recently used Battery Pack to cool completely before charging. Also make sure the Battery Pack is undamaged; do not charge a cracked or leaking pack.
2.Insert Charger’s plug into a grounded, 120V~ outlet. Then slide Battery Pack into Charger’s battery port, making sure Battery Pack’s tabs snap into place and Battery Pack is secure before charging.
Battery Pack
Green
Light
Red Light
Charger
3.The green light will activate once Charger is plugged in. The green light will continue to light and the red light will flash during charging.
NOTE: Normal charging time after use is about 1 hour.
4.When Battery Pack is fully charged, both red and green lights will stay lit.
NOTE: If both the green and red lights of the charger are blinking simultaneously, the charger or the battery is defective.
NOTE: Batteries will not reach full charge the first time they are charged. Allow for several cycles (drilling and recharging) before the Tool is fully charged.
5.Press Battery Pack’s side tabs and pull Pack from the Charger and unplug the Charger from the wall outlet.
Note: Do not use a battery pack immediately after charging. Allow it to cool first. Store the Charger and Battery Packs not in use indoors, away from children.
SKU 68126 | For technical questions, please call | Page 9 |