are found, do not use tool until repaired.
Tool Set Up
To prevent serious injury
from accidental operation: Turn tool off and remove Battery Pack before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury: Do not adjust or tamper with any control or component in a way not specifically explained within manual. Improper adjustment can result in tool failure or other serious hazards.
Charging
1.Please refer to the Charger manual for important safety warnings and proper instructions on charging the Battery Pack (40).
2.WARNING! Do NOT use a different Charger or Battery to power this Drill.
General Operating Instructions
1.Note: When tool is not being used or when battery, drills, or screwdriver bits are being attached or removed, slide Direction Selector (38) to its
2.Note: To change direction of rotation,
ALWAYS release Trigger allowing motor to come to complete stop first.
3.This Drill is designed to accept up to
3/8” shank size standard drill bits, as
well as hex shank screwdriver bits and bit holder adapters. Do not use larger size drill bits as damage to gears/motor may result. Always use a drill bit that is designed for specific drilling job
4.Slide Direction Selector (38) to its
5.Turn Torque Selector (6) to the de- sired setting and then slide charged battery pack onto base of tool until locked into position. Gently pull on battery to ensure that it is locked securely. Slide Direction Selector to right for drilling / fastening or to left for reversing.
6.Place one hand over top of housing for greater tool stability. With other hand grip handle and gently squeeze
Trigger to activate motor. Use Cylin- drical Vial Level (45) at rear
7.Do not force bit. Excessive force will damage tip and lead to tool failure.
8.If drill bit becomes stuck, immediately release Trigger allowing tool to come to complete stop. Slide Direction Selector to left to its reverse position and squeeze Trigger.
9.To prevent accident and injuries, when not in use, remove the attach- ment and the battery pack from the tool.
SKU 67024 | For technical questions, please call | Page 8 |