10.Note:
RECYCLED OR DISPOSED OF PROPERLY. Do not short, incinerate or open Battery Pack.
Maintenance And
Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation: Turn off tool and remove Battery before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury from tool failure: Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning, Maintenance, and
Lubrication
1.BEFORE EACH USE, inspect the general condition of the tool. Check for loose hardware, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wir- ing, and any other condition that may affect its safe operation.
2.After Use, wipe external surfaces of the tool with clean cloth.
3.When storing, always store Impact Wrench in clean, dry and safe loca- tion out of reach of children.
Troubleshooting
Problem | Possible Causes | Likely Solutions |
Tool will not start. | Battery not charged. | Charge Battery. |
Hammer function not | Selector Ring in drilling position. | Slide Selector Ring into hammering position. |
available. |
|
|
Performance | Accessory dull or damaged. | Keep accessories sharp. Replace as needed. |
decreases over time. |
|
|
Excessive noise or | Internal damage or wear. | Have technician service tool. |
rattling. |
|
|
Overheating. | 1. Forcing tool to work too fast. | 1. Allow tool to work at its own rate. |
|
| 2. Keep cutting accessories sharp. Replace |
| 2. Accessory dull or damaged. | as needed. |
|
| 3. Wear |
| 3. Blocked motor housing vents. | |
|
| blowing dust out of motor using compressed |
|
| air. |
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power supply before service.
SKU 67024 | For technical questions, please call | Page 9 |