Tilting to the right
1
007659
1. Positive stopper
NOTE:
• | Returning the blade to the right angle makes the | ||
| shifting lever return to 0° by itself. | ||
Sighting |
|
| |
| 1 | 2 | 1. Base |
| 2. Cutting line | ||
|
|
| |
|
| A |
|
|
| B |
|
Turn the positive stopper so that the arrow on it points one of two positions (vertical for 22.5°, horizontal for 45°). Loosen the clamping screws in front and back. Then, tilt the tool base until it stops and secure the base with the clamping screws.
To get 48° bevel angle, move the lever to 48° marking as far as it will go. Turn the positive stopper so that the arrow on it points to the horizontal position. Then, tilt the tool base until it stops and secure the base with the clamping screws.
1 | 1. Lever |
| |
|
|
007660
007671 |
When using the tool without guide rail (accessory) For straight cuts, align the A position on the front of the base with your cutting line. For 45° bevel cuts, align the B position with it.
When using the tool with guide rail (accessory)
For both straight cuts and 45° bevel cuts, always align the A position on the front of the base with your cutting line.
Switch action
1 | 1. | |
2 | 2. | Switch trigger |
|
|
Tilting to the left
1 |
007661 |
1.Bevel angle shifting lever
007664
CAUTION:
•Before plugging in the tool, always check to see that the switch trigger actuates properly and
returns to the "OFF" position when released.
To prevent the switch trigger from being accidentally pulled, a
The tool can be tilted to the left 1° bevel angle. To get the left 1° bevel angle, loosen the clamping screws in front and back, tilt the tool handle slightly to the right and push two bevel angle shifting levers at the same time in the direction of arrow which has a marking
Speed adjusting dial
1 |
007663 |
1.Speed adjusting dial
8