Makita BTD146, BTD134 instruction manual Assembly, Installing or removing driver bit or socket bit

LED indicator status Remaining battery capacity

About 50% or more

About 20% - 50%

About less than 20%

012023

NOTE:

•Before checking the remaining battery capacity, be sure to stop the tool.

ASSEMBLY

CAUTION:

•Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool.

Installing or removing driver bit or socket bit

004521

Use only bits that has inserting portion shown in the figure.

For tool with shallow bit hole

A=12mm Use only these type of bit. Follow the
B=9mm	procedure (1).
	(Note) Bit-piece is not necessary.
006348

For tool with deep bit hole

A=17mm	To install these types of bits, follow
B=14mm	the procedure (1).
A=12mm	To install these types of bits, follow
	the procedure (2).
B=9mm	(Note) Bit-piece is necessary for
	installing the bit.

011405

1.	To install the bit, pull the sleeve and insert the bit
	into the sleeve as far as it will go.
	1. Bit
	2. Sleeve
1	2
012063

2.To install the bit, insert the bit-piece and bit into the sleeve as far as it will go. The bit-piece should be inserted into the sleeve with its pointed end facing in. Then release the sleeve to secure the bit.

2	1.	Bit-piece
	2.	Bit
	1
012013

To remove the bit, pull the sleeve and pull the bit out.

NOTE:

•For all countries other than Europe, it's not necessary to pull the sleeve when installing the bit.

•If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above.

•When it is difficult to insert the bit, pull the sleeve and insert it into the sleeve as for as it will go.

•After inserting the bit, make sure that it is firmly secured. If it comes out, do not use it.

7