Williams Sound Model WIR 237 Model WIR 238 Model WIR 239 manual Case of Difficulty

Page 17

IN CASE OF DIFFICULTY

If the system does not seem to be functioning:

1.Read through the manual and user guide carefully to verify proper setup and installation of your system.

2.Make sure that your television or VCR is plugged in and turned on.

3.Make sure that the TX238 Transmitter’s power adapter is plugged in.

4.If you’ve installed the TX238 Transmitter other than on top of the TV, make sure that its front panel is facing the receiver.

5.Make sure that the receiver has a fully charged battery.

6.Make sure you are not covering the infrared “eye.” Remove any objects obstructing the line between the TX238 Transmitter and the receiver. The “SoundPlus” label should be facing towards the TV while you listen.

7.If you are using the RX237 or RX238 Receiver and getting static or hiss: Try operating the TX238 Transmitter in MONO (2.3 MHz or 2.8 MHz) mode. See instructions on page 8.

8.If you are using the RX239 (neckloop) Receiver, and the sound is weak or noisy: First, make sure that the TX238 Transmitter is operating in 2.3 (Mono) mode. Also, check that the T-coil switch on your hearing aid is switched to the “On” position. Next, try increasing the volume on the receiver unit, then increase the vol- ume on your hearing aid until the volume is at a comfortable lis- tening level.

9.If you are operating the TX238 Transmitter in MONO (2.3 MHz or 2.8 MHz) mode and getting noise or hiss in the receiver: For 2.3 MHz operation, check to make sure you are only using the left RCA jack on the TX238 Transmitter. For 2.8 MHz operation: make sure you are only using the right RCA jack on the TX238 Transmitter.

10.If you are using the TV microphone and not getting a signal, try turning up the TV volume up slightly. Also, try positioning the TV mic directly over the TV speaker.

11.If the system still does not function, call Williams Sound at: 1-800-843-3544.

®

17

Image 17
Contents Model WIR Contents System Components System OverviewHearing Safety Safety InformationRecycling Instructions Pacemaker SafetySetting UP the TX238 Transmitter Connect the Transmitter Power Supply Stereo Operation MHz Mono Operation Setting UP the RX237 Receiver Additional Receiver Adjustments RX237 Receiver Front View Setting UP the RX238 Receiver RX238 Receiver Rear View Setting UP the RX239 Neckloop Receiver RX239 Receiver Rear View Case of Difficulty Limited Warranty Page WIR 238, WIR WIR RX237 Receiver WIR RX239 Receiver Page Williams Sound Corp. MAN 120C