CONNECTIONS
1 | Hold the cable of the display unit with the connection plug facing up, and insert the plug into the |
display unit connector of the control unit. |
| PUSH |
| MENU/OK |
DISPLAYMODE | VOL |
| |
| POWER |
| To display unit |
| connector |
| * The connection plug |
Display cable | should face upward. |
DISPLAYMODE | VOL |
| |
| POWER |
*To unplug the display cable, pull it out by pressing the disconnect buttons on both sides of the connection plug simultaneously.
ENGLISH
2 Plug the AC adapter into the AC adapter (DC IN) connector of the control unit and into a power outlet.
AC adapter
Power outlet
or
To AC adapter (DC IN) connector
3 | Make sure to set the POWER switches of the control unit and connected video component to |
| OFF, then connect the AV cable to the audio/video input jack of the control unit and to the output |
jacks of the video component as shown in the figure.
To audio/video input jack
To audio/video output jacks (pin jacks)
|
|
| Video component |
|
|
| such as a VCR, LD |
Video | Audio | Audio | player, DVD player, |
(Yellow) | Left | Right | etc. |
| (White) | (Red) |
|
|
|
| * Be sure to connect to |
|
|
| the audio/video |
|
|
| output jacks on the |
|
|
| video component. No |
|
|
| audio/video can be |
|
|
| output if the AV cable |
|
|
| is connected to the |
| AV cable (provided) |
| audio/video input |
|
| jacks. | |
|
|
|
Note: If your video component is monaural, you will hear the audio only through one earphone.