Kramer Electronics Operating the RC-53D K-NET Auxiliary Control Panel, Commands Configuration

Operating the RC-53D K-NET™ Auxiliary Control Panel

7Operating the RC-53D K-NET™ Auxiliary Control Panel

In the following example1 (illustrated in Figure 9), the auxiliary control panel is labeled with specific functions and each button is programmed2 to perform several tasks3 as defined in Table 4.

Table 4: The Commands Configuration

Figure 9: RC-53D Labels Setup

The Label	The Macro Sequence
ON	•	Power up the projector
	• Power up the DVD player
	• Roll down the projector screen
	• 1 minute delay (for the projector to heat up)
	• The projector selects the DVD input
OFF	•	Power down the projector
	• Stop the DVD player
	• Power down the DVD player
	•	Stop the VCR
	• Power down the VCR
	• Roll up the projector screen
DVD	•	Stop the video player
	• The projector selects the DVD input
	•	Play the DVD
VCR	•	Stop the DVD
	• The projector selects the VCR input
	•	Play the VCR
VOLUME	•	Use the VOLUME knob to adjust the audio
		level

1 This is only one example among numerous possibilities, each button can be programmed as required. In this example, two buttons are not assigned

2 By the technical installer

3 A macro sequence, including several commands per button, carried out one after the other

9