Sy s t e m S e t u p
Wii Console Usage Precautions
Please read and follow the precautions listed below when
setting up and using the Wii console. Failure to do so may result in damage to your Wii system or accessories.
•Do not use any AC Adapter other than the one provided with your system.
•The console has intake and exhaust vents designed to maintain adequate ventilation. Do not operate the console in any location where these vents may become covered or obstructed, for example, on carpet or in a tightly enclosed space. Keep vents clear of any dust or other foreign material.
•Do not disassemble or try to repair the Wii console, accessories or components. Doing so voids your warranty.
•After you have finished playing, be sure to remove the Game Disc from the console.
•Do not store the Wii console in a humid place, on the floor, or in any location where it may collect dirt, dust, lint, etc.
•Do not drop, hit or otherwise abuse the Wii console, components or accessories.
•When disconnecting any plugs from the console or wall outlet, first turn the Wii console off. Then carefully pull by the plug itself rather than by the cord.
•Do not step on, sharply pull or bend any wire or cables.
•Do not expose the Wii console, components or accessories to extreme heat or cold.
•Do not spill any liquids on the Wii console, components or accessories.
To clean, use a soft slightly damp cloth. Use water only. Allow to dry completely before using.
System Setup
10
Wii Console Placement
NOTE: Choose a location to set up the console that has enough room to allow for free flow of ventilation around the console.
The Wii console can be placed in a vertical or horizontal position. If located in a vertical position, it should be placed in the Wii console stand.
VerticalHorizontal
CAUTION - Console Damage
The console can be damaged if knocked over, especially if this occurs during operation of the disk drive. The Wii stand plate has been included to increase stability of the Wii console, and should be used if the console is placed in a vertical position.
Vertical Placement
1. Attach the Wii stand plate to the bottom of the | 2. Firmly slide the stand plate into slots in the | 3. Place the console stand on a flat surface and |
console stand by inserting the prongs into the | direction shown. | place the console into the stand. Lower the |
slots as shown above. |
| console straight down into the console |
|
| stand rather than sliding it in from the |
|
| front. |
Horizontal Placement
Place the Wii console on a flat horizontal surface. Retain the Wii console stand and stand plate for future use in case you want to switch the orientation of the console.
System Setup
11