Controller Connector

12	Basic Operation Instructions

Battery Condition Meter

The battery condition meter consists of ten lights arranged in an arc over the on/off key. As the battery voltage drops, the number of lights reduces from right to left. When the battery capacity drops to 10% or below, the left red LED will flash.

!Left Red LED Flashing: Battery charge is low; charge the batteries as soon as possible.

!Right-to-Left Ripple of LEDs: FLIGHT is in lock mode; unlock the FLIGHT.

!Left-to-Right Ripple of LEDs Alternating with Steady Display: FLIGHT is in programming, inhibit, or charging mode.

!Right Green LED Flashing: FLIGHT is in speed limit mode.

!All LEDs Flashing Continuously: The joystick was not in the neutral position when the controller was turned on. If you get “all LEDs flashing continuously,” turn off the controller, allow the joystick to return to the neutral position, then turn on the controller.

!All LEDs Flashing Quickly (Code): The FLIGHT has detected a fault; refer to the Error Code table.

Speed Keys

There are two keys that control the speed. Press the speed increase key to in- crease the speed. Press the speed decrease key to decrease the speed. The speed setting is displayed on the speed setting indicator. If your power chair was pro- grammed with a drive profile, contact your authorized Pride Provider for more information.

NOTE: We recommend that the first few times you operate your power chair, you set the speed to the slowest setting until you become familiar with your new power chair.

Horn Key

The horn key activates a warning horn.

This connects the FLIGHT to the power module located on the power base.

FLIGHT Controller