StarTech.com ST121SHD50 manual Edid Factory Default Setting, DDC Pass Mode

Page 10

EDID Factory Default Setting

To avoid confusion in which EDID information has been copied or for more purposes, this function enables to reset the state to factory default.

Step 1. Use CATx cable for connection between Tx & Rx on Aux RJ-45 Jack. Apply power to Receiver Unit.

Step 2. Press the button “EDID Copy” and release the button RIGHT AFTER the LED flashes red.

Step 3. The LED flashes green & red indicating default setting successfully.

DDC Pass Mode

Press the button for more than 15 sec. and release right after the LED flashes green. The LED lights blue indicating setting successfully. To exit this mode, follow “EDID Factory Default Setting” steps.

Instruction Manual

Image 10

Contents Hdmi over Cat 5e/6 Extender 50m FCC Compliance Statement Table of Contents Rear View Product DiagramTop View Front ViewIntroduction Packaging ContentsSystem Requirements LED Indicator Status TransmitterHardware Installation InstallationPreparing Your Site Video Adjustment Receiver Unit Only OperationAuto Edid Configuration Edid ConfigurationManual Edid Configuration Edid Copy / Edid Ghost Edid Factory Default Setting DDC Pass ModeSpecifications Technical Support Warranty Information Limitation of Liability