Calibrating the Stylus
Mark on Screen
Tip of
Stylus
IMPORTANT!
From time to time, the mark made on your screen from the stylus and the location of the tip of the stylus may not align. When this happens, you must calibrate the stylus.
•Turn Pixter® over and locate the calibration hole.
•Insert, push and hold the stylus in the calibration hole. Turn Pixter over
so that you can see the screen. When you see two 
,you can remove the stylus from the calibration hole.
•First touch the upper right corner 
with the tip of the stylus.
•Then, touch the lower left corner 
with the tip of the stylus.
13