Sharp AF-S120DX, AF-S100DX, AF-R120DX, AF-100DX, AF-R140DX Front panel. Keep them as they will

Page 6

INSTALLATION INSTRUCTIONS

2

(1) Unscrew the 2 screws at the corners of

the front panel. Keep them as they will

be used later.

(2)Remove the front panel by pulling the front panel at the lower corners towards you about an inch.

Front panel

Next lift it up and pull it towards you.

CAUTION:

Horizontal

Louver

Front

Exhaust Lever

panel

 

Take care not to damage the exhaust lever when removing the front panel.

3 (1)Unscrew the 6 stopper screws of the cabinet. Keep the 4 screws from the top and front , as they will be used later.

(2)Slide the chassis out from the cabinet by pulling on the hand hold located at the bottom center of the chassis.

CAUTION:

Do not remove any material (ex. styrofoam, etc.) from inside the unit.

4 Insert the right closure assembly and the left closure assembly into the top angle and the bottom channels.

Secure the right and left closure to the

cabinet with 6 of the provided screws. (L=13 / 32 ", 10 mm)

5 Open the window sash and place the cabinet on the sill.

Close the window sash securely behind the top angle.

If there is space between the bottom channel and the sill, fill the gap with a thin board or other hard filler.

WARNING

At this step, make sure the cabinet is in- clined approximately 1 cm (3/8”) to the back.

If the cabinet is not properly inclined, the water collected in the bottom tray during operation will not drain properly and may flow into the room where the air conditioner is installed.

Closure assembly

Cabinet

sill

incline backwards about 1cm (3/8")

 

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents AF-R100DX AF-R120DX AF-R140DX Accessories Additional Customer Information For Your ProtectionConsumer Limited Warranty Consumer Limited WarrantyInstallation Instructions Check Window AreaLocation Installation Items Packed with this UnitSuggested Tools Front panel. Keep them as they will Secure the cabinet to the window Precautions Grounding InstructionsPrecautions Energy Efficiency TipsHOW to Operate 987To Change Temperature Setting Touch Power ON/OFF padON/OFF pad again During operation Change FAN Speed and Operation ModeOperation mode and fan speed Touch Selector pad and selectExhaust Energy SaverTo Change AIR Flow Direction During cooling operation Touch Energy Saver padOn Timer Operation When the unit is not operating1delay d start time OFF Timer Operation When the unit is operatingTo Cancel the Timer Setting Using the Remote Control Use two size-AAA R03 batteriesTransmitter Cleaning and Maintenance Remove the FilterAIR Conditioner does not Operate AT ALL Timer does not Work ProperlyIf the Unit Fails to Receive the Remote Control Signal AIR Conditioner does not Properly CoolSharp Electronics Corporation

AF-R140DX, AF-100DX, AF-R120DX, AF-S120DX, AF-S100DX specifications

The Sharp AF series air conditioners, including models AF-R140DX, AF-100DX, AF-S120DX, AF-S100DX, and AF-R120DX, are renowned for their advanced cooling technologies, energy efficiency, and user-friendly features. These units are designed to provide comfort in varying climate conditions while ensuring optimal energy consumption.

One of the standout features of the AF series is its Intelligent Cooling technology. This innovation allows for faster cooling times, enabling the units to reach the desired temperatures quickly, enhancing comfort during hot summer months. Additionally, these models incorporate a multi-stage filtration system, which includes a pre-filter and HEPA filter, ensuring that the air circulated is clean and free from dust, allergens, and pollutants.

Energy efficiency is a critical characteristic of the AF series. With a high Energy Efficiency Ratio (EER), these air conditioners minimize electricity consumption while providing effective cooling. This not only helps reduce utility bills but also contributes to a smaller carbon footprint, aligning with environmental sustainability goals.

The AF-R140DX and AF-R120DX models come equipped with inverter technology, allowing for variable speed compressor operation. This feature adjusts the cooling output according to the room's temperature, thereby maintaining a consistent environment without unnecessary energy expenditure. The AF-100DX, AF-S120DX, and AF-S100DX models also offer impressive performance but differ in cooling capacity and design suited for specific room sizes.

Moreover, user convenience is a priority with the AF series. Most models include a simple-to-use remote control functionality, allowing users to adjust settings from a distance. The programmable timer and sleep mode ensure that homeowners can set cooling schedules according to their preferences, enhancing comfort while optimizing energy usage.

Design-wise, Sharp’s AF air conditioners boast a sleek and modern appearance that can fit seamlessly into any room decor. Their compact size makes them suitable for both residential and commercial spaces.

In summary, the Sharp AF-R140DX, AF-100DX, AF-S120DX, AF-S100DX, and AF-R120DX air conditioners stand out with their intelligent cooling capabilities, energy-efficient operation, advanced filtration systems, and user-friendly designs, making them ideal solutions for those seeking comfort and efficiency in air conditioning.
Top Page Image Contents