Sharp KC-860EK, KC-850EK Water Supply Indicator Light, Sound indicator setting for water supply

Page 12
Press the Fan Speed Button to set the desired sensor sensitivity.
With the unit OFF, press the Fan Speed Button for 3 seconds.
The Fan Speed Indicator Lights will display the currently set sensor sensitivity level. The factory setting is Standard, indicated by the MED light.

OPERATION

Plasmacluster ON/OFF Button

Press the Plasmacluster ON/OFF Button to turn Plasmaclus- ter Ion Mode ON and OFF.

When Plasmacluster is ON, both the Indicator Light and Plasmacluster Indicator Light turn on.

LIGHTS CONTROL Button

Use when the light on the front panel is too bright.

Refer to the diagram to select the desired brightness on the front panel.

｢

 

｣

 

The lights on the front panel are brighter.

｢

 

｣

 

The lights on the front panel are darker.

｢

 

｣

 

The lights on the front monitor turn off

CAUTION The lights on the front monitor are always brighter when starting.

WATER SUPPLY INDICATOR LIGHT

When the Water Tank is empty, the Water Supply Indicator Light will fl ash to indicate that the Water Tank should be refi lled. Please note the light will not flash even when the Water Tank is empty during the Clean Air Mode and the Clean ION SHOWER Mode.

Sound indicator setting for water supply.

Flashing

In addition to the Indicator Light, the unit can be set to signal with an audible beep when the Water Tank is empty. With the unit OFF, press the Lights Control button for 3 seconds to turn the audible signal ON.

Cancellation

To cancel the audible signal, with the unit OFF, press the Lights

Control button again more than 3 seconds.

ADJUSTMENT OF SENSOR DETECTION SENSITIVITY

Set to “low” if the DUST MONITOR and ODOUR MONITOR is constantly red to reduce sensitivity, and set to “high’ if the DUST MONITOR and ODOUR MONITOR is constantly green to increase sensitivity.

1

2

Refer to the diagram on the right to select the desired sensor sen-

 

sitivity level.

 

 

3

Press the Power OFF Button.

Note that if the Power OFF Button is not pushed within 8 seconds

 

of adjusting sensor sensitivity, the setting will be saved automati-

 

cally. The sensor sensitivity setting will be saved even if the unit is

 

unplugged.

Fan Speed

Sensor

Indicator

Detection

Light

sensitivity

 

High

 

Standard

 

Low

E-10

Page 11 Page 13
Image 12
Page 11 Page 13
Contents KC-850EK KC-860EK Free standing type床置き・卓上兼用型 Please read before operating your new Air Purifier English Important Safety Instructions Clean the exterior with a soft cloth only Avoid locations where grease or oily smoke is generatedAir Outlet Main Unit Display Front Monitor Handle 2 locations left and right SensorsTank Handle Water TankPlasmacluster Indicator Light blue Water Supply Indicator Light redHumidity Indicator Light green Install the Hepa Filter Fill in the usage start date on the Date LabelAfter filling, securely tighten the Tank Cap Replace the Water Tank in the unitClean AIR & Humidify Mode About Automatic Humidify ModeClean AIR Mode Clean ION Shower ModePress the Clean AIR Mode Button on the display Water Supply Indicator Light Sound indicator setting for water supplyPress the Power OFF Button Use when the light on the front panel is too brightWhen the back panel has stubborn dirt UnitDo not use volatile fluids Do not use detergentsCare Cycle Every day when Humidifying Water TankWashable Deodorizing Filter Care Replace the filter in unit. See E-6Humidifying Tray Rinse the HumidifyingImpurities Replace the Humidifying Filter and reHumidifying Filter Remove the Water Tank Humidifying TrayRemove the Humidifying Filter from the Humidifying Tray Preparing the descaling solu- tionFilter Replacement Guidelines Washable Deodorizing FilterGreen even when the air is Air is cleanWhen cigarette smoke is Filter Indicator Light isError Display MAX Other Countries outside the EU Memo 日本語 English お使いになる前に 一般の具体例は「KC-850EK」を使用していますトリプルフィルター＋プラズマク ラスター＋加湿の組み合わせによ る独自の空気浄化技術 ホコリを除去 ニオイを除去空気清浄 洗えるプレフィルターが空気中の大 きなちりほこりを捕集します安全上のご注意 火災や感電、けがを防ぐ ご使用前にお読みください。漏電やけがを防ぎ、家財を守る お使いになる人や他の人への危害、財産への損害を防止するため、お守りいただくことを説明 しています。使用上の注意 設置についてフィルターについて テレビやラジオ、電波時計など電波を利用する機器からは約 2m 離して置く。各部のなまえ 吹出口 操作部 前面モニターとって 吹出口 センサー部ダストモニター プラズマクラスターイオンランプ 青ニオイモニター 給水ランプ 赤ご使用前の準備 フィルターの取り付け洗える脱臭フィルター Hepa フィル ター 白 をポリ袋から 取り出す。 Hepa フィルターを取り付ける。 水色側が手前タンクに水を入れる タンクをはずす。 タンクキャップをはずし、タンクに水を入れる。給水後はタンクキャップをしっかり締 める。締める タンクを本体に取り付ける。運転のしかた 加湿空気清浄運転タンクに水を入れる。 加湿空気清浄ボタンを押す。 風量切換ボタンで、お好みの風量を選ぶ。空気清浄運転 イオンシャワー運転空気清浄ボタンを押す。 イオンシャワーボタンを押す。プラズマクラスターイオンの入／切 給水ランプについてセンサー感度を調整する 運転停止中に 風量切換ボタンを 3 秒以上押す。お手入れ フィルターお手入れランプ お手入れ時期 1カ月に1回、後ろパネルとセンサー部 後ろパネルの汚れがひどいときタンク 洗える脱臭フィルター水分をよくきる。 タンクキャップ お手入れ時期 1カ月に1回トレー 加湿フィルター 水質により、加湿フィルターのお手入れ時期は異なります。 トレーをはずすときやお手入れ時、水こぼれに注意してください。汚れがひどいとき お手入れ前に、クエン酸やレモン ジュースを溶かした水、またはぬ るま湯に 30 分、つけ置きをする。 21/2 カップの水または、ぬるま 湯にクエン酸約スプーン 3 杯を 溶かす。フィルターの交換について 集じんフィルター 5年に1回洗える脱臭フィルター 加湿フィルター 2年に1回トラブルシューティング こんなときは 確認してください 故障ではありませんくり返しエラー表示になるときは、お買いあげの販売店に連絡ください。 ランプ表示 エラー内容 処置方法風量 m 空気清清浄浄消費電力 W 空清適用床面積 m タンク容量 L日本語 TINS-A379KKRZ 09K- CN

KC-850EK, KC-860EK specifications

The Sharp KC-850EK and KC-860EK are advanced air purifiers designed to enhance indoor air quality while providing comfort and convenience. Both models showcase Sharp's commitment to creating innovative solutions for a healthier home environment.

One of the standout features of the KC-850EK and KC-860EK is their powerful Plasmacluster ion technology. This unique technology generates positive and negative ions that effectively eliminate airborne pollutants, allergens, and odors. By mimicking the natural process of ionization found in nature, these units can create a fresher, more invigorating atmosphere within any room.

Both models come equipped with a high-performance HEPA filter that captures up to 99.97% of particles as small as 0.3 microns, including dust, pollen, smoke, and pet dander. This ensures that the air you breathe is cleaner and safer. Additionally, the KC-850EK and KC-860EK feature an activated carbon filter that neutralizes odors, making them ideal for homes with pets or smokers.

The design of the KC-850EK and KC-860EK is both sleek and functional. They are compact enough to fit into various living spaces while maintaining a modern aesthetic. The intuitive control panel allows users to easily adjust settings and monitor air quality in real time, providing a user-friendly experience.

Another impressive characteristic of these models is their air quality indicator, which changes color based on the level of pollutants detected in the environment. This feature allows users to see the effectiveness of the air purifier at a glance, providing peace of mind and encouraging proactive management of indoor air quality.

Both the KC-850EK and KC-860EK also feature a silent operation mode, ensuring that they can run quietly in the background, without disrupting your daily activities or sleep. The units automatically adjust their fan speed based on the air quality, optimizing energy consumption while maintaining optimal performance.

In terms of maintenance, Sharp has designed these models with user convenience in mind. The filters are easy to replace, and a filter replacement indicator alerts users when it's time to change them, ensuring consistent air purification.

Overall, the Sharp KC-850EK and KC-860EK air purifiers represent a perfect blend of advanced technology, efficient filtration, and user-friendly design, making them excellent choices for anyone looking to improve their indoor air quality and create a healthier living space.
Top Page Image Contents