2.Connect the Fibre Channel cables from the switch to your host and storage devices. Ensure that the physical connections match the connections on the Device Connection screen.
a.Remove the plastic protector caps from the Fibre Channel cable ends (if there are any), and position the cable connector so that it is oriented correctly.
b.Position a cable so that the key (the ridge on one side of the cable connector) is aligned with the slot in the transceiver (see
Figure 9 (page 7)).
c.Insert the cable into the transceiver until the latching mechanism clicks.
d.The Device Connection screen shows missing, valid, and invalid connections as you cable the switch. It can take up to 15 seconds for the screen to display the connection as valid. Verify that the connections display green and then click Next.
Verify switch operation
1.Check the LEDs to verify that all components are functional. For information about LED patterns, see the HP
2.Verify the correct operation of the switch by issuing the switchShow command.
This command provides information about switch and port status.
3.Verify the correct operation of the fabric by issuing the fabricShow command.
This command provides general information about the fabric.
4.Back up the switch configuration to an FTP server by issuing the configUpload command and following the prompts.
This command uploads the switch configuration to the server, making it available for downloading to a replacement switch if necessary.
Set switch features
This completes the initial setup of your HP SN6000B or SN3000B 16Gb FC Switch. See the HP StorageWorks Fabric OS 7.0.x Administrator's Guide and the Fabric OS 7.0.x Command Reference Manual for detailed instructions on setting all supported switch features.
Page 8