LED | State |
Temp | On (green) |
|
|
| Blinking (orange) |
|
|
Fan Status | On (green) |
|
|
| Blinking (orange) |
|
|
PoE Status | On (green) |
|
|
| Off |
|
|
| Blinking (orange) |
|
|
LED | State |
RPS Status | On (green) |
|
|
| Off |
|
|
| Blinking (orange) |
|
|
EPS Status | On (green) |
|
|
| Off |
|
|
| Blinking (orange) |
|
|
On (green) | |
Status |
|
|
|
| Off |
|
|
| Blinking (orange) |
|
|
Port LEDs | Link (green) |
(Link and |
|
Mode) |
|
Mode (green)
LED Mode | Act (green) | |
Select |
| |
FDx (green) | ||
|
Indication
Internal temperature is normal.
An over temperature condition has been detected.
Normal operation.
One of the unit’s fans has failed. The switch Fault LED will be blinking simultaneously.
If any ports are supplying PoE power.
If no ports are supplying PoE power. Should be off only during the boot process.
If any port has an internal hardware failure, blinks once every
1.6seconds. If any port is denied PoE power or detecting an external PD fault, blinks once every 0.5 seconds.
Indication
Normal operation. RPS is connected and operating correctly. RPS could be powering the unit.
RPS is not connected or is not powered on.
RPS is connected, but has experienced a fault.
Connected to an EPS, and receiving power.
The switch is not connected to an EPS.
The EPS is connected but has experienced a fault or is unplugged.
Expansion module is plugged in to expansion slot and operating correctly.
Expansion module is not plugged in to expansion slot.
Expansion module is plugged in to expansion slot but has experienced a fault.
Indicates the port LEDs are displaying link information:
•If the port LED is on, the port is enabled and receiving a link indication from the connected device.
•If the port LED is off, the port has no active network cable connected, or is not receiving link beat or sufficient light. Otherwise, the port may have been disabled through the switch console, the Web browser interface, or HP ProCurve Manager.
If the port LED is blinking (orange) simultaneously with the Fault LED, the corresponding port has failed its
The operation of the Mode LED is controlled by the LED Mode select button, and the current setting is indicated by the LED Mode indicator LEDs near the button. Press the button to step from one view mode to the next. The default view is Activity (Act).
Flickers to show relative activity.
Flickers to show relative activity.
62