HP Ps1810-8g J9833AABA manual

Wall Mounting: Install two 5/8-inch (15.875 mm) Number 12 wood screws, (included) into the mounting surface, positioned 6.3 inches (160 mm) apart. Use the wall anchors if necessary. Then, position the switch over the screws and slide to lock in place.

Important: For wall-mounting, the network ports must be	2
	1
facing up or down. (See “Installation Precautions” on
page 6.)

3

Under-Surface Mounting: Install the two screws on the surface bottom similarly to the procedures for wall mounting. Then, position the switch over the screws and slide to lock in place. Install the third screw at the side of the switch to prevent it from sliding out of the locked position, if necessary.

1

1

2

1

3 2

2