HP 2500 manual Web Viewing Existing Port Trunk Groups, HP2512config# no interface 1 lacp

Optimizing Port Usage Through Traffic Control and Port Trunking

Port Trunking

	Removing Ports from a Dynamic LACP Trunk Group. To remove a port
	from dynamic LACP trunk operation, you must turn off LACP on the port. (On
	a port in an operating, dynamic LACP trunk, you cannot change between LACP
	dynamic and LACP passive without first removing LACP operation from the
	port.)
C a u t i o n	Unless STP is running on your network, removing a port from a trunk can
	result in a loop. To help prevent a broadcast storm when you remove a port
	from a trunk where STP is not in use, HP recommends that you first disconnect
	the link on that port.
	Syntax: no interface <port-list>lacp
	In this example, port 1 belongs to an operating, dynamic LACP trunk. To
	remove port 1 from the dynamic trunk and return it to passive LACP, you would
	do the following:
	HP2512>(config)# no interface 1 lacp
	HP2512>(config)# interface 1 lacp passive
	Note that in the above example, if the port on the other end of the link is
	configured for active LACP or static LACP, the trunked link will be re-
	established almost immediately.

Web: Viewing Existing Port Trunk Groups

While the web browser interface does not enable you to configure a port trunk group, it does provide a view of an existing trunk group.

To view any port trunk groups:

Click on the Status tab.

Click on [Port Status].

Optimizing Port Usage Through Traffic Control and

6-23