Open the cover of the ink vehicle | Put in the cartridges of CISS | Cover the lid and | make sure | the |
Put out the original cartridges |
| cartridges are in | the right | position |
3. Installation of the support arm
We have installed the support arm in the cartridges
Put another short support arm in the middle of groove
Put the long support arm 3.5cm right to the short one and 10cm down.
Close the tubes to the support arm by clasp, and make sure the tubes are not contorted
4、Adjust he tubes
Pull out the power wire, then move |
| move it to the left end | pull the tubes straight, the tube can not | ||
the Ink vehicle |
|
| be that long or contorted. | ||
|
|
|
|
|
|
|
|
|
|
|
|
Move the ink vehicle to the left, whether there is baffle
In the same way, move it to the right installation finished , whether it will hit anywhere