Using Your AIR Conditioner

Electronic Control Panel & Remote Control

NOTE: This display always shows the room temperature in Fan Mode except when setting the Set temperature or the Timer.

When the light is on the unit is in temperature or timer set mode.

Air Conditioner Controls

Normal Operating Sounds

•You may hear a pinging noise caused by water hitting the condenser, on rainy days, or when the humidity is high. This design feature helps re- move moisture and improve efficiency.

•You may hear the thermostat click when the com- pressor cycles on and off.

•Water will collect in the base pan during rain or days of high humidity. The water may overflow and drip from the outside part of the unit.

•The fan may run even when the compressor is not on.

1.Power Button: Turns the air conditioner on and off

2.Digital Display: Under ON status without timer setting,the operation mode is Auto, Cool, Energy Saver or Dry mode,and the set temperature will be displayed.

Under ON status without timer setting, the operation mode is fan mode and the ambient temperature will be displayed.

Time will be displayed under timer setting or timer preview.

3.Temperature Set: Use these buttons on the con- trol panel and remote to increase or decrease the Set Temperature (the desired room temperature) in cooling,energy saver and dry mode. The SET light will light up when setting the temperature

4.Timer Set: Use these buttons on the control panel and remote to set the Timer. Each press of the Timer (DELAY) buttons will increase or de- crease the timer. For timer instructions see #7.

5.Fan Speed & Auto Fan: Use the fan speed but- tons to change the fan speed. Choose between low, medium, high, and Auto.

6.Mode Button: Press the mode button to cycle

through the various modes: Cooling, Energy Saver, Fan only, Dry (Dehumidifier) and Auto.

7.Auto-on Timer: When the air conditioner is off, it can be set to automatically turn on in 0.5-24 hours at the previous set mode and fan setting. To set the Auto-on Timer, press the TIMER button on the unit or remote control. The timer can be set in 0.5 hour increment below 10 hours and in 1 hour increment for 10 hours or above.

The Set light will turn on while setting.

Auto-off Timer: When the air conditioner is on, it can be set to automatically turn off in 0.5-24 hours. To set the Auto-off Timer, press the TIMER button on the unit or remote control. The timer can be set in 0.5 hour increment below 10 hours and in 1 hour increment for 10 hours or above. The SET light will turn on while setting.

•To see the remaining time, press the TIMER Button. To change the timer setting use the ▲/▼ on the unit or the +/- buttons on the remote.

•During preview of timer or timer setting, press Timer button on the panel or remote controller to cancel the timer setting.

8.Filter Check: After the fan rotates for 250 total hours, the filter check light will turn on to remind the user to clean the filter. Press the Filter check button once the filter is cleaned to reset the re- minder.