To Remove the Front Panel | Soleus Air GM-CAC-08ESE, GM-CAC-10SE

INSTALLATION—CASEMENT

INSTALLING THE UNIT IN A CASEMENT WINDOW (CONT.)

11. Cut side channel seal into 2 equal lengths.

Remove the protective backing and apply it to the rear side of the cabinet side channels, starting just below the panel frame assembly. Pinch off excess length so the seal is even with the bottom of the cabinet side channel.

12.To Remove the Front Panel

1.Remove the two front retaining screws from the front frame.

2.Press firmly on each side of the metal case close to the front, approximately 2/3 of the way down.

3.While pressing on the sides of the metal case, gently pull the front out and lift up to re- lease it from the case.

4.Then remove the four screws from the front frame to release the control panel box.

NOTE: DO NOT push or pull the air direction louvers.

13. Place the air conditioner in the window

opening as shown to the right. It should sit on the platform assembly so that the window panel frame, and the cabinet side channels are against the top and side window jambs. Side channels should overlap side window jambs equally.

14.Drill two 9/64-inch diameter pilot holes in the top window jamb in line with the partially plugged holes in the panel frame. Secure the panel fame to the window jamb with two #8- 32x3/4-inch self-threading screws. If additional holding is necessary, two screws may be used on the sides of the panel frame as well.

15.Drill two screw-clearance holes in the cabi- net side channels (near bottom) and two 9/64- inch diameter pilot holes in the side window jambs. Secure the cabinet side channels to the window jambs with two #8-32x3/4-inch self- threading screws. When doing this, be careful not to twist the side channel seals with the screws.

NOTE: Inserting screws will prevent the air conditioner from being pushed into the room.

16. To replace the front

First reconnect the coupler plugs, make the exhaust control positioned through the front in the proper location.

Gently push the front into position on the cabinet. It should click into place. Then replace the retaining screws that holds the panel in place.