Soleus Air GM-CAC-12SE, GM-CAC-10SE, GM-CAC-08ESE manual Preparing for Installation, Disclaimer

Page 5

PREPARING FOR INSTALLATION

PREPARING FOR INSTALLATION

Installation Tips

For wood-frame casement windows: It may be necessary to construct a frame, using at least 1-inch thick wood, with a 15-1/2-inch wide opening.

For brick or cement building construction: It may be necessary to put a wood stool strip under AC, for mounting pur- poses.

Tools Required:

Flat-head screwdriver

Phillips-head screwdriver

Carpenter's level

Tape measure

Fine tooth saw

Electric or hand drill

Knife and scissors

Pencil

WARNING: Failure to adhere to the following precautions could result in personal injury and product damage.

Because this unit weighs about 88 to 105 pounds, it is recommended that you have someone help you when install your new unit, and that you both use proper lifting techniques.

Inspect the condition of the window where unit will be installed. Be sure it will support the weight of the unit.

This appliance must be installed according to all applicable codes and ordinances.

Handle AC with care. AVOID sharp metal fins on front and rear coils.

Make sure your AC does not fall during installation.

Do not use water collected in the unit for drinking. It is not sanitary.

DISCLAIMER

ALL INFORMATION AND THE TECHNICAL SPECIFICATIONS PRESENTED IN THIS USER’S MANUAL ARE THE PRESENTATION OF THE MANUFACTURER. SOLEUS INTERNATIONAL HAS NOT CONDUCTED INDEPENDENT TEST TO THE INFORMATION AND THE SPECIFICATIONS PRESENTED HEREWITHIN.

5

Image 5
Contents GM-CAC-08ESE GM-CAC-10SE GM-CAC-12SE Important Safety Instructions GM-CAC-08ESE GM-CAC-10SE GM-CAC-12SE SpecificationsMeeting Electrical Requirements Receptacle WiringElectrical Requirments Electrical ConnectionDisclaimer Preparing for InstallationPreparing for Installation Parts List & Installation Installing the Unit in a Sliding Window InstallationSecurely attach a siding-protection board to INSTALLATION-SLIDINGTo remove front To replace the front Alternate Window Jamb ApplicationsInstalling the Unit in a Casement Window INSTALLATION-CASEMENTSlide the plastic window panel into the panel Clamp the plastic window panel between aFasten the side channels to the sides Place the air conditioner in the window Cut side channel seal into 2 equal lengthsTo Remove the Front Panel Electrical Information For Your SafetyAccident Prevention Operation of Current Device Control Panel Touch PAD Operating Your AIR ConditionerRemote Control Operating Your AIR Conditioner AIR Conditioner Features Air Filter Cleaning Taking Care of Your AIR Conditioner Care and CleaningProblem Possible Causes Solutions TroubleshootingWater is dripping inside the room TroubleshootingWarranty