HP 8100 manual Additional Features, Description

QuickSpecs

HP Compaq 8100 Elite PC

Technical Specifications
Additional Features	Description
Computrace	Computrace agent included; separate software and subscription required
DT or MT Orientation	Product can be oriented in either a tower or desktop orientation
Drive Lock	Implementation of the industry standard ATA Security feature set. When enabled,
	it prevents software access to user data on the drive until one or two user-defined
	passwords are provided.
Drive Protection System	DPS Access through F10 Setup during Boot
	A diagnostic hard drive self test. It scans critical physical components and
	every sector of the hard drive for physical faults and then reports any faults
	to the user.
	Running independently of the operating system, it can be accessed through
	a Windows-based diagnostics utility or through the computer's setup
	procedure. It produces an evaluation on whether the hard drive is the source
	of the problem and needs to be replaced.
	The system expands on the Self-Monitoring, Analysis, and Reporting Technology
	(SMART), a continuously running systems diagnostic that alerts the user to certain
	types of failures.
SMART Technology (Self-Monitoring,	Allows hard drives to monitor their own health and to raise flags if imminent
Analysis and Reporting Technology)	failures were predicted
SMART I – Drive Failure Prediction	Predicts failures before they occur. Tracks fault prediction and failure
	indication parameters such as re-allocated sector count, spin retry count,
SMART II – Off-Line Data Collection	calibration retry count
	By avoiding actual hard drive failures, SMART hard drives act as "insurance"
SMART III – Off-Line Read Scanning	against unplanned user downtime and potential data loss from hard drive
with Defect Reallocation	failure
	IOEDC: I/O Error Detection Circuitry
SMART IV – End-to-End CRC for hard	Detects errors in Read/Write buffers on HDD cache RAM
drives	Interface in F10 setup provides confirmation of SMART IV support.

DA - 13524 Worldwide QuickSpecs — Version 14 — 6/24/2010 Page 18