HP 8100 manual Slots, Bays, Controller, Unit Environment and Operating Conditions

QuickSpecs

HP Compaq 8100 Elite Series

Technical Specifications

Slots	Small Form Factor	Convertible Minitower
PCI Slot	(1) low profile PCI slot	(3) full height PCI slot
	25W max power	25W max. power
PCI Express x16	(2) low profile PCIe x16 graphics slot	(2) full height PCIe x16 graphics slots
	35W max power	75W max. power - primary slot
		35W max. power - secondary slot
		Note:
		Secondary slot functions as a x4 slot
PCI Express x1	(1) low profile PCIe x1 slot	(1) full height PCIe x1 slot

Bays		Small Form Factor	Convertible Minitower
External	3.5”	(1) bay available for Media Card Reader	N/A
		unless used for a secondary hard drive

5.25”(1) bay available for Optical Disc Drive 8.19” deep

3 bays

Top two bays accept drives up to 8.19” depth Bottom bay accepts drives up to 5.7”depth

Controller	Small Form Factor	Convertible Minitower
Hard Drive Controller	Serial ATA
	Supports SATA 1.5-GB/s and 3.0-GB/
SATA Interfaces	(3) common SATA	(4) common SATA
	(1) eSATA	(1) eSATA
Host SATA Controller	(1) low profile PCIe x1 slot	(1) full height PCIe x1 slot

Unit Environment and Operating Conditions

General Unit Operating Guidelines

Keep the computer away from excessive moisture, direct moisture and the extremes of heat and cold, to ensure that unit is operated within the specified operating range.

Leave a 10.2 cm (4 in) clearance on all vented sides of the computer to permit the required airflow. Never restrict airflow into the computer by blocking any vents or air intakes.

Do not stack computers on top of each other or place computers so near each other that they are subject to each other's re- circulated or preheated air.

Occasionally clean the air vents on the front, back, and any other vented side of the computer. Lint, dust and other foreign matter can block the vents and limit the airflow.

If the computer is to be operated within a separate enclosure, intake and exhaust ventilation must be provided on the enclosure, and the same operating guidelines listed above will still apply.

Temperature Range	Operating: 50° to 95° F (10° to 35° C)*
	Non-operating: –22° to 140° F(–30° to 60° C)
Relative Humidity	Operating: 10% to 90% (non-condensing at ambient)
	Non-operating: 5% to 95% (non-condensing at ambient)
Maximum Altitude	Operating: 10,000 ft (3048 m)
(unpressurized)	Non-operating: 30,000 ft (9144 m)

DA - 13524 Worldwide — Version 24 — April 22, 2011 Page 18