HP NC510C manual Technician notes, Where to go for additional help

Page 4

Technician notes

In this section

 

Warnings, cautions, and notes

4

Where to go for additional help

4

Warnings, cautions, and notes

WARNING: Only authorized technicians trained by HP should attempt to repair this equipment. All troubleshooting and repair procedures are detailed to allow only subassembly/module-level repair. Because of the complexity of the individual boards and subassemblies, no one should attempt to make repairs at the component level or to make modifications to any printed wiring board. Improper repairs can create a safety hazard.

WARNING: To reduce the risk of electric shock, personal injury, and damage to the equipment:

Do not attempt to service any parts of the equipment other than those specified in the following procedure. Any other activities may require that you shut down the server and remove the power cord.

Installation and maintenance of this product must be performed by individuals who are knowledgeable about the procedures, precautions and hazards associated with the product.

WARNING: To reduce the risk of electric shock or damage to the equipment:

Do not disable the power cord grounding plug. The grounding plug is an important safety feature.

Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times.

Unplug the power cord from the power supply to disconnect power to the equipment.

Do not route the power cord where it can be walked on or pinched by items placed against it. Pay particular attention to the plug, electrical outlet, and the point where the cord extends from the server.

CAUTION: To properly ventilate the system, you must provide at least 7.6 cm (3.0 in) of clearance at the front and back of the server.

CAUTION: The server is designed to be electrically grounded (earthed). To ensure proper operation, plug the AC power cord into a properly grounded AC outlet only.

NOTE: Any indications of component replacement or printed wiring board modifications may void any warranty.I

Where to go for additional help

In addition to this guide, information about software drivers and utilities is available on the HP ProLiant Networking Software CD that shipped with the adapter.

HP updates networking software frequently to include new functionality and features. For the latest driver, firmware, and documentation updates go to the HP website (http://h18004.www1.hp.com/products/servers/networking/index.html).

Technician notes 4

Image 4
Contents HP NC510C PCle 10 Gigabit Server Adapter User Guide Part Number 437524-00B February 2007 Second EditionAudience assumptions Contents Where to go for additional help Technician notesHP contact information Introduction LED indicatorsOverview LED indicator Status Description Installation overview Installing an adapterPreventing electrostatic discharge Installing an adapter in a server Installing a low profile bracketSpecifications General specificationsCX4 Twin-axial cable CompliancePower and environmental specifications CX4 connector pinout descriptionPower Value Environmental Specifications Pin Signal name Connector pinSpecifications Regulatory compliance notices Regulatory compliance identification numbersClass a equipment ModificationsCanadian notice Regulatory compliance notices Electrostatic discharge Grounding methods to prevent electrostatic dischargeAcronyms and abbreviations Index