4 Connecting to a Windows NT Server 4.0
Windows 95 SR2
Windows 95 SR2 | Requirements |
| • HP Vectra with Windows 95 SR2. |
| • Intel EtherExpress PRO ISA ethernet card and drivers disk Ver. 2.3. |
| • Driver Name: El90X.DOS Size: 45KB Date: 3/21/97 |
| • Microsoft Windows NT Server 4.0 machine that supports Net BEUI,TCP/ |
| IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols. |
Device Configuration
• | I/O Address | 350 - 35Fh |
• | Interrupt | IRQ 10 |
• | Board Connector type | |
• | Force | Yes |
• | Flash chip address | Disabled |
• | Remote boot program | None |
Procedure
1With the HP Vectra turned off, install the Intel EtherExpress PRO ISA adapter card into an ISA slot.
2Connect network cable media to the Intel EtherExpress PRO ISA card.
3Insert a DOS bootable diskette and power on the machine.
4After booting, insert the Intel EtherExpress drivers disk, “EtherExpress drivers Ver. 2.3.”, and execute “A:\SOFTSET2.EXE.”
5Select “Configure NIC”, and verify the resource settings listed above under the heading “Device Configuration.”
6If changes are required, save those changes and exit.
7Remove the Intel EtherExpress software driver diskette and reboot the machine.
8Power on the machine and allow it to boot to Windows 95.
9When Windows 95 restarts, a message will appear that new hardware has been found.