HP Vectra with Windows 95 SR2 | HP 3C590-TPO manual

3 Connecting to a Windows NT Server 3.51

Windows 95 SR2

Windows 95 SR2	Requirements
	• HP Vectra with Windows 95 SR2.
	• 3COM Etherlink 3C509-B Ethernet card and drivers disk ver 5.0.
	Driver Name: Elnk3.Vxd Size: 30.2KB Date: 7/18/96
	• DOS and MS-Windows for Workgroups 3.11 media.
	• Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/
	IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

•	I/O Base Address	300
•	Interrupt Request Level	10
•	Boot PROM	Disabled
•	Transceiver Type	Auto Select
•	Network Driver Optimization	Windows or OS/2 Client
•	Maximum Modem Speed	9600 Baud
• Plug and Play Compatibility		Disabled
•	Full Duplex	Disabled

1With the HP Vectra turned off, install the 3COM Etherlink III 3C509-B adapter card into an ISA slot.

2Connect network cable media to the 3COM 3C509B card.

3Insert a DOS bootable diskette and power on the machine.

4After booting, insert the 3COM drivers disk “Etherlink 3C509-B Ethernet Drivers Ver. 5.0.” and change to Drive A: , and execute “3C5X9CFG.EXE.”

5Select “Configure NIC,” and verify the resource settings listed above under the heading “Device Configuration.”

6If changes are required, save those changes and exit.

7Remove the 3Com Software driver diskette and reboot the machine.

8Click on “Start” and point to “Settings”, then select the “Control Panel.”

9In the Control Panel group, double click on the “Network” icon .

• HP Vectra with Windows 95 SR2.