HP MR4000N manual Setup, Rear Panel Connectors

Page 12

Setup

Rear Panel Connectors

RF Input (labeled AIR 75 ohm)

Connect an outdoor or indoor antenna.

Monitor Out

Connect composite cables to your TV or monitor. Insert the yellow video cable into the Video connector and the white and red cables into the Audio L and R connectors, respectively.

Component Out

Connect component cables to your TV or monitor. Insert the green, blue, and red video cables into the Y, Pb, and Pr connectors and the white and red cables into the Audio L and R connectors, respectively.

Digital Audio Out

Connect a cable from the digital audio input of your audio receiver.

Resolution Select

Choose a resolution setting that corresponds with the TV or monitor you are using.

•1080i (interlaced scanning): Use this setting if you have an HDTV-ready 16:9 (wide screen) aspect ratio TV monitor with HDTV-ready component video inputs that can handle the 1080i video output format.

•720p (progressive scanning): Use this setting for an HDTV-ready 16:9 (wide screen) aspect ratio TV monitor with HDTV-ready component video inputs that can handle the 720p video output format.

•480p (progressing scanning): Use this setting for a digital-ready 4:3 aspect ratio TV monitor with progressive scan DTV-ready component video inputs that can handle the 480p video output format. The TV monitor may be labeled as “enhanced definition” or “progressive scan.”

•480i (interlaced scanning): Use this setting for a conventional TV with composite video.

4Setup

Page 11 Page 13
Image 12
Page 11 Page 13
Contents HP MR4000N Hdtv Tuner User’s Guide USA Important Safeguards Do not OpenPage Page Page Table of Contents Troubleshooting Specifications Safety Installing the HP Hdtv TunerFirst Precautions Introduction What’s in the BoxSetup Rear Panel ConnectorsIdentifying Your Component’s Cables DTV Out Select YPbPr/DVIDVI/RGB Out Connecting the HP Hdtv Tuner Connecting an indoor/outdoor antennaConnecting to a TV with a DVI connector Connecting to a TV with a component connector YPbPrConnecting to an analog TV composite Connecting a splitter for Picture-In-Picture TVsConnecting audio equipment Using the HP Hdtv Tuner Front Panel ControlsUsing the Remote Control Identifying the remote control buttonsUsing the Electronic Program Guide EPG Installing or replacing the remote control batteriesUsing the On-Screen Menu Using the Main MenuUsing the Channel Menu Using auto memorizing to set up your channelsProgramming favorite channels Adding and deleting channelsFine tuning channels Using the Caption Menu Adjusting the signal strengthAnalog mode Turning captions on and offDigital service Digital service infoUsing the Lock Menu Digital service fontTV FCC subcategories for content Important notes about parental locksTV FCC age categories Using the Setup Menu Screen formatRatio Time ZoomPillar box Daylight SavingSound Analog Multi-Channel Television Sound MTSDigital language Digital outputVideo noise reduction analog channels only Electronic Program Guide EPG digital channels onlyDynamic range compression Troubleshooting Problem RemedySpecifications General SpecificationsRF Specifications Agency Regulatory Notice Federal Communications Commission NoticeModifications CablesIndex IndexVideo noise reduction Index
Top Page Image Contents