HP MR4000N Connecting to an analog TV composite, Connecting a splitter for Picture-In-Picture TVs

Page 15

Connecting to an analog TV (composite)

1Connect your indoor or outdoor antenna to the RF Input (labeled AIR 75 ohm).

2Insert the yellow cable into the Video connector in the Monitor Out section.

3Insert the white and red audio cables into the L and R Audio connectors of the Monitor Out section.

4Insert the other end of the yellow cable into the Composite In connector of your TV.

5Insert the other ends of the white and red audio cables into the L and R In connectors of your TV or audio receiver. Make sure they correspond with your composite input.

6Select 480i for your Resolution setting.

Connecting a splitter for Picture-In-Picture TVs

To use the Picture-in-picture feature on your TV, use a splitter (not included) to connect your HDTV Tuner.

1Connect your indoor or outdoor antenna to the splitter.

2Connect one cable from the splitter to the RF Input (labeled AIR 75 ohm) on the HDTV Tuner.

3Connect another cable from the splitter to the RF connector on your TV.

Connecting audio equipment

This connection enables Dolby Digital* quality sound, when available. Use with an external digital audio receiver decoder. See “Digital Output” on page 20 for configuring your HDTV Tuner to output the appropriate audio format for your receiver.

Insert the cable from the Digital Audio Input of the audio receiver into the Digital Audio Out connector on your HDTV Tuner. Refer to your TV documentation to locate the Digital Audio Input connector.

*Manufactured under license from Dolby Laboratories. “Dolby” and the Double-D symbol are trademarks of Dolby Laboratories.

Setup 7

Page 14 Page 16
Image 15
Page 14 Page 16
Contents HP MR4000N Hdtv Tuner User’s Guide USA Do not Open Important SafeguardsPage Page Page Table of Contents Troubleshooting Specifications Safety Installing the HP Hdtv TunerFirst Precautions What’s in the Box IntroductionRear Panel Connectors SetupIdentifying Your Component’s Cables DTV Out Select YPbPr/DVIDVI/RGB Out Connecting to a TV with a component connector YPbPr Connecting the HP Hdtv TunerConnecting an indoor/outdoor antenna Connecting to a TV with a DVI connectorConnecting to an analog TV composite Connecting a splitter for Picture-In-Picture TVsConnecting audio equipment Front Panel Controls Using the HP Hdtv TunerIdentifying the remote control buttons Using the Remote ControlInstalling or replacing the remote control batteries Using the Electronic Program Guide EPGUsing the Main Menu Using the On-Screen MenuAdding and deleting channels Using the Channel MenuUsing auto memorizing to set up your channels Programming favorite channelsFine tuning channels Turning captions on and off Using the Caption MenuAdjusting the signal strength Analog modeDigital service info Digital serviceDigital service font Using the Lock MenuTV FCC subcategories for content Important notes about parental locksTV FCC age categories Using the Setup Menu Screen formatRatio Daylight Saving TimeZoom Pillar boxDigital output SoundAnalog Multi-Channel Television Sound MTS Digital languageVideo noise reduction analog channels only Electronic Program Guide EPG digital channels onlyDynamic range compression Problem Remedy TroubleshootingSpecifications General SpecificationsRF Specifications Cables Agency Regulatory NoticeFederal Communications Commission Notice ModificationsIndex IndexVideo noise reduction Index
Top Page Image Contents