HP MP4 manual Removing the stand, Using the power cord retention slot

Page 10

Removing the stand

To remove the stand:

1.Turn the unit upside down.

2.Press the tab (1), and then slide the stand about 1.26 cm (1/2 inch) toward the back of the unit and lift the stand (2) off the unit .

Figure 1-5Removing the stand

Using the power cord retention slot

To prevent accidental disconnection, press a loop of the power cord into the power cord retention slot.

Figure 1-6Power cord retention slot (example showing horizontal orientation)

4 Chapter 1 Product features

Image 10

Contents Hardware Reference Guide First Edition February Document Part Number About This Book Iv About This Book Table of contents Preventing electrostatic damage Grounding methods Standard features Product featuresFront panel components Installing the rubber feet Rear panel componentsInstalling the stand 4Installing the standUsing the power cord retention slot Removing the standUsing the keyboard Ctrl keyWindows Logo Key Serial number locationAdditional function keys General hardware installation sequence Hardware changesRemoving the side access panel 2Removing the side access panel Removing the left metal side coverReplacing the side access panel Replacing the left metal side coverRemoving and replacing the battery Installing digital signage player options Installing a SodimmPage Page Page Installing a flash memory module Page Installing external drives Specifications Table A-1HP MP4 Digital Signage PlayerSecurity provisions Securing the digital signage playerMounting the digital signage player HP Quick ReleasePage Figure C-4Connecting the digital signage player Supported mounting optionsPage Routine digital signage player care Digital signage player operationSupported orientations Page Non-supported orientation Preventing electrostatic damage Electrostatic dischargeGrounding methods Shipping information Important service repair informationShipping preparation Index