Hard drive
NOTE: The hard drive spare part kit includes a hard drive bracket and hard drive connector. The hard drive bracket and hard drive connector, as well as the hard drive bracket screws, are also available in the Hard Drive Hardware Kit.
Description | Spare part number |
|
|
Supports the following 9.5 mm / 7.0 mm, 6.35 cm (2.5 in) SATA hard drives: |
|
|
|
320 GB, 7200 rpm | |
|
|
Hard Drive Hardware Kit (not illustrated, includes connector, bracket, and screws) | |
|
|
Before removing the hard drive, remove the following components:
1.Battery (see Battery on page 30)
2.Service door (see Service door on page 31) Remove the hard drive:
1.Use the rubber tab on the hard drive bracket (1) to move the hard drive to the left and disconnect it from the hard drive adapter.
2.Lift the hard drive (2) out of the hard drive bay.
3.To replace the hard drive bracket, remove the four Phillips 3.0×3.0 screws (1) that secure the hard drive bracket to the hard drive.
32 | Chapter 4 Removal and replacement procedures |